Braun Oral-B PROFESSIONAL CARE Smart 5000 Serie Mode D'emploi page 8

Masquer les pouces Voir aussi pour Oral-B PROFESSIONAL CARE Smart 5000 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

approximately in a 3-month period. If the bristles
splay before the color recedes, you may exert too
much pressure on teeth and gums.
We do not recommend using the Oral-B FlossAction
or Oral-B ProWhite brush head with braces. You
may use the Oral-B Ortho brush head, specifically
designed to clean around braces and wires.
Synchronizing your toothbrush
To avoid interference of display messages when
using more than one Oral-B Triumph toothbrush with
SmartGuide in the same household, you need to
assign the handles to their respective SmartGuide.
You can synchronize a maximum of 2 handles with
one SmartGuide. To do so, push the «h/min» button
in the battery compartment for at least 3 seconds.
The SmartGuide shows «L---». Turn on your handle
to start the synchronization process. It is finished
when «L-1-» is displayed. Turn off the handle. To
assign a second handle to the same SmartGuide turn
on the other handle until «L-2-» is displayed. After
having synchronized the second handle, «Full» will
be displayed. Exit the synchronization mode by
pressing the «h/min» or «set» button, otherwise it
will end automatically after 30 seconds.
Cleaning recommendations
After brushing, rinse your brush head under running
water with the handle switched on. Switch off and
remove the brush head. Clean handle and brush
head separately; wipe them dry before reassembling.
Disassemble the charging unit before cleaning. Brush
head compartment and protective cover are dish-
washer-safe. Both basic charger and SmartGuide
should be cleaned with a damp cloth only (picture 5,
page 5).
Wall mount
Use the adhesive tape (k) if you prefer to mount the
SmartGuide on a wall, mirror or other surface. Make
sure the chosen surface is clean and dry. Position
the wall mount (j) with the Oral-B logo readable and
press it evenly and firmly to the wall. Wait 24h before
sliding the SmartGuide into the fixed wall mount
(picture C, page 4). The adhesive tape will not work
on dirt-repellent surfaces.
98728793_D34_NA.indd 9
98728793_D34_NA.indd 9
Subject to change without notice.
Environmental Notice
PRODUCT CONTAINS NICKEL-METAL
HYDRIDE RECHARGEABLE BATTERIES.
MUST BE RECYCLED OR DISPOSED OF
PROPERLY.
Removing batteries
Handle battery
At the end of the product's useful life, open the
handle as shown, remove the rechargeable battery
and dispose of it according to local environmental
regulations.
1
4
2
3
5
6
7
Caution! Opening the handle will destroy the
appliance and invalidate the warranty.
SmartGuide batteries
Remove fully discharged batteries immediately.
Replace all batteries at the same time. Do not mix
alkaline batteries with zinc carbon or rechargeable
batteries.
9
30.03.11 15:44
30.03.11 15:44

Publicité

Table des Matières
loading

Table des Matières