•
If the machine emits smoke or odours, or if it behaves unusually, you
must turn off its power immediately by pressing the power switch.
After turning off the power, be sure to disconnect the power cord plug
from the wall outlet. Then contact your service representative and
report the problem. Do not use the machine. Doing so could result in
fire or electric shock.
•
If metal objects, or water or other fluids fall inside this machine, you
must turn off its power immediately by pressing the power switch.
After turning off the power, be sure to disconnect the power cord plug
from the wall outlet. Then contact your sales or service representa-
tive and report the problem. Do not use the machine. Doing so could
result in fire or electric shock.
•
If the machine topples, or if a cover or other part gets broken, you
must turn the power switch to off and disconnect the power cord plug
from the wall outlet. Then contact your service representative and
report the problem. Do not use the machine. Doing so could result in
fire or electric shock.
•
Do not touch this machine if a lightning strike occurs in the immedi-
ate vicinity. Doing so could result in electric shock.
•
Keep the polythene materials (bags, etc.) supplied with this machine
away from babies and small children at all times. Suffocation can
result if polythene materials are brought into contact with the mouth
or nose.
R
CAUTION:
•
Unplug the power cord from the wall outlet before you move the machine.
While moving the machine, take care that the power cord is not damaged
under the machine. Failing to take these precautions could result in fire or
electric shock.
•
Before installing or removing options, always remove the power cords from
the wall outlet and allow time for the main unit to fully cool. Failing to take
these precautions could result in burns.
•
For environmental reasons, do not dispose of the machine or expended
supply waste at household waste collection points. Disposal can take place
at an authorized dealer.
•
When moving the machine, hold the inset grips at both sides, and then lift
the printer slowly. Lifting it carelessly or dropping it may cause an injury.
Important
Rating voltage of the connector for options: Max. DC 24 V.
Voltage must not fluctuate more than 10%.