Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Programming
The sensor is programmed using the two buttons "Mode/Enter" and
"Set".
First call a parameter with the "Mode/Enter" button, select the reque-
sted value with the "Set" button and confirm it pressing again the
"Mode/Enter" button.
1
MODE
SET
ENTER
2
MODE
SET
ENTER
3
MODE
SET
ENTER
Change more parameters:
4
Start again with step 1.
* Decrease the value: Let the display move to the maximum setting
value. Then the cycle starts again at the minimum setting value.
20
All manuals and user guides at all-guides.com
Press the Mode/Enter button until
the requested parameter
is displayed.
Press the Set button and keep it
pressed. The indicated current
parameter value flashes for 5 s,
then it is increased*
(incremental by pressing briefly or
scrolling by holding pressed).
Press the Mode/Enter button
briefly (= acknowledgement). The
parameter is displayed again, the
new parameter value becomes
effective.
Finish programming:
Wait for 15 s or press the Mode/
Enter button until the current
measured value is displayed again.
Publicité
Table des Matières
