MINN KOTA MKR-26 Mode D'emploi page 7

11
ITEM(S) NEEDED
#12 x 1
ab. The Splicer and Shrink Tube should be added to the
Plug Receptacle so it can be attached to the Boat
Wires. Take the Plug Receptacle (Item #B) and place
one Shrink Tube (Item #6), followed by one Splicer
(Item #12) on the end of the black Negative (-)
Wire of the Plug Receptacle. Secure the Splicer by
tightening the Set Screw with a 3/32" Allen Wrench
to 20 in-lbs.
ac. Take the Plug Assembly and identify the red Positive
(+) Power Lead on the Plug Assembly and align
it with the Positive (+) Power Lead on the Trolling
Motor Wires. Insert it into the Splicer at the end of
the Positive (+) Lead Wire from the Plug Assembly.
Take the black Negative (-) Power Lead from the Plug
Assembly and align it with the Negative (-) Power
Lead from the Trolling Motor Wire. Insert it in the
Splicer at the end of the black Negative (-) Power
Lead of from the Trolling Motor Wires. Secure the Set
Screw of both Splicers with the Allen Wrench.
12
ad. Once the Splicers are secure on both wires, take the
Shrink Tubes and slide them over the Splicers. The
Shrink Tubes should be centered over the Splicer
and completely cover the wire connections.
NOTICE:
The Shrink Tubes are meant to water
proof the connection between the Plug Receptacle
and the Boat Wires. Make sure there are no gaps
around the wires that would allow water to reach the
connection.
ae. When satisfied with the position, secure the Shrink
Tubes in place with a Heat Gun. Then slide the
Splice Cover over the Shrink Tubes to complete the
installation.
NOTICE:
When disconnecting the plug assembly
from the receptacle, be sure to install and tighten the
Dust Cap. This will prevent water or debris intrusion.
For warranty information, please visit minnkotamotors.com.
minnkotamotors.com
Part #2377118
#6 x 1
11ab
11ad
Minn Kota Consumer & Technical Service
Johnson Outdoors Marine Electronics, Inc.
PO Box 8129
Mankato, MN 56001
ECN 41038
Plug Plug
Assembly Assembly
Negative Power Negative Power
Lead (-) Lead (-)
Positive Power Positive Power
Lead (+) Lead (+)
Shrink Tube Shrink Tube
Splicer Splicer
Plug Assembly Plug Assembly
Shrink Tube Shrink Tube
NOTICE:
When connecting the plug assembly from
the receptacle, be sure to tighten the Threaded Collar to
ensure a proper water tight seal is achieved to protect
electrical contacts. Failure to tighten the Threaded Collar
could result in water intrusion.
121 Power Drive
Mankato, MN 56001
Phone (800) 227-6433
Fax (800) 527-4464
11ac
Plug Plug
Assembly Assembly
Negative (-) Negative (-)
Power Lead Power Lead
Positive (+) Positive (+)
Power Lead Power Lead
Shrink Shrink
Tube Tube
Splicer Splicer
Splicer Splicer
Shrink Shrink
Tube Tube
Negative (-) Negative (-)
Power Lead Power Lead
Positive (+) Positive (+)
Power Lead Power Lead
Trolling Trolling
Motor Wires Motor Wires
11ae
Threaded Threaded
Collar Collar
Plug Assembly Plug Assembly
Splice Cover Splice Cover
©2021 Johnson Outdoors Marine Electronics, Inc.
All rights reserved.
Rev D 03/21