User Manual
English
7. 5V DC: Connect the included 5VDC 1A power supply.
8. Optical In: Connect to the transmitter unit using a single-mode or multi-mode fibre cable.
9. HDMI Out: Connect to an HDMI source device.
10. 3.5mm Audio Out: Connect to an external audio output.
11. RS-232: RS-232 commands can be passed through over the fibre connection.
Control Operation
Bi-directional IR Control
The IR control function allows you to control the source
device from the display side of the installation. It also provides
the ability to control the display from source side of the
installation.
IR Pin assignment can be seen here:
Bi-directional RS-232 Control
The RS-232 control function allows you to control the installation using two separate RS-232 devices,
such as a PC and a projector or digital signage from the transmitter to receiver, or control the source
device from the receiver side of the installation from a wall mounted control panel. To use this function,
ensure all RS-232 cables are correctly connected from the unit's terminal blocks. Please note the pin out
on the units.
RS-232 Baud Rate: 4800-115200bps
Please note all connected devices must support RS-232.