Lindy 38174 V2 Manuel Utilisateur page 6

User Manual
Product Layout
Transmitter
1. Power LED: Indicates power is provided to the transmitter unit.
2. Optical Link LED: Illuminates when a link has been made between the transmitter and receiver units.
3. HDMI Link LED (In): Illuminates when a link has been made between the transmitter and source
device.
HDMI Link LED (Loop): Illuminates when a link has been made between the transmitter and local HDMI
display.
4. IR In: Connect the included IR receiver cable and ensure the IR eye is in a clear line of sight.
5. IR Out: Connect the included IR emitter cable and ensure the IR eye is in a clear line of sight.
6. Audio EDID Switch: Position the dipswitch to select the audio signal source. When no video signal is
used as an input, audio signals can be transmitter separately.
7. EDID Switch: Position the dipswitch to select the desired EDID:
11: Copy Rx HDMI Out
10: Copy Tx HDMI Loop Out
01: 4K60_2CH
00: 1080P_2CH
8. Update: Reserved for future firmware updates.
9. 5V DC: Connect the included 5VDC 1A power supply.
10. Optical Out: Connect to the receiver unit using a single-mode or multi-mode fibre cable.
11. HDMI Out: Connect to a local HDMI display.
12. HDMI In: Connect to an HDMI source device.
13. 3.5mm Audio In: Connect to a 3.5mm audio source device.
14. RS-232: RS-232 commands can be passed through over the fibre connection.
Receiver
1. Power LED: Indicates power is provided to the receiver unit.
2. Optical Link LED: Illuminates when a link has been made between the transmitter and receiver units.
3. HDMI Link LED: Illuminates when a link has been made between the receiver and display device.
4. IR In: Connect the included IR receiver cable and ensure the IR eye is in a clear line of sight.
5. IR Out: Connect the included IR emitter cable and ensure the IR eye is in a clear line of sight.
6. Update: Reserved for future firmware updates.
English