Mstation 2.1 Stereo Orb Guide De L'utilisateur page 7

Line In Connections
To connect an audio device with a 1/8" headphone jack, insert one end of the supplied
stereo mini plug audio cable into the jack labeled "Line In" located in the back at the
base of the mStation Orb™. (See Detail B of the diagram on page 4.) Insert the other
end of the cable into the 1/8" headphone jack or audio out jack of the audio device.
Proceed to the section titled "Operations" below.
mStation Orb™ and Remote Control Buttons
Operation
Once the appropriate connections have been made, your mStation Orb™ is ready
to operate. All functions are performed by using the Control Buttons on the top of
the mStation Orb™ or on the Remote Control. A description of the Control Buttons is
shown below:
out of the battery tray to activate the Remote Control. Make sure that the battery tray is
completely inserted before operating the Remote .
These three buttons work with any audio source connected to the mStation Orb™:
Standby/On
POWER
when the unit is on. In Standby mode the status light glows amber.
Volume Down/Volume Up
PREV NEXT
VOLUME
Bass/Treble (Remote Control only)
BASS PLAY/PAUSE TREBLE
These buttons adjust the tone settings of the mStation Orb™ speakers.
The following buttons are used to control an iPod that is connected to the mStation
Orb™ docking port:
Previous/Rewind
Next/Fast Forward
Play/Pause
Pressing and holding this button turns the iPod off.
All manuals and user guides at all-guides.com
When a source is connected to the Line In jack on the mStation Orb™, playback
from devices connected to the docking port is disabled. To listen to one of these
sources, you will need to remove the mini plug cable from the Line In jack.
Before using the Remote Control you must remove the factory-inserted plastic
tab designed to prevent the battery from prematurely discharging. The tab is
found at the bottom (rounded-end) of the Remote. Simply pull the entire tab
When the mStation Orb™ AC power adapter is plugged into an AC source,
pressing this button toggles from Standby (no audio output or device control)
to On (speakers on and all controls functional). The status light glows blue
These buttons raise and lower the volume of the mStation Orb™
speakers. Every time you turn on the unit, the volume level starts
from zero.
Pressing this button once starts a song over again. Pressing this button twice
skips to the previous song. Pressing and holding this button rewinds through
the song.
Pressing this button once skips to the next song. Pressing and holding this
button fast forwards through the song.
If your iPod is turned off, pressing this button turns it on and begins play
of the last song selected. If your iPod is already on, pressing this button
begins play of the selected song. Pressing this button again pauses the song.