Stryker Unity Dreme 3500 Manuel page 28

3. Using two hands, lift up on the bottom of the bench to flip the bench onto its back.
C C A A U U T T I I O O N N - - Always confirm stable foot placement and back support or get assistance from another person to avoid the
risk of injury or product damage.
4. Using a flat screwdriver and diagonal pliers if needed, remove the staples that secure the front of the bottom cover to the
bottom of the bench frame.
5. Using a flat screwdriver and diagonal pliers if needed, remove the staples that secure the sides of the bottom cover to
the bottom of the bench frame.
N N o o t t e e - - Remove the side staples about eight inches down from the front.
6. Using a #2 Phillips screwdriver, remove the screw (I) that secures the P-clamp (H) to the back frame (Figure 12).
7. Remove the hook and loop fastener that secures the power cord to the bench frame.
N N o o t t e e - - If there is a cable tie in place of the hook and loop fastener, use diagonal pliers to cut the cable tie that secures
the power cord to the bench frame.
8. Using a #3 Phillips screwdriver, remove the eight screws (E) that secure the front panel (F) (Figure 7). Save the screws.
Remove and discard the panel.
9. Reverse steps to reinstall.
10. Using two hands, lift up on the back of the bench to flip the bench onto its feet or casters.
C C A A U U T T I I O O N N - - Always confirm stable foot placement and back support or get assistance from another person to avoid the
risk of injury or product damage.
11. Pull the handle on the front of the bench to make sure there is enough slack between the cable tie and the outlet/USB.
N N o o t t e e - - If there is not enough slack to pull out the sleeper pullout completely, adjust the cable tie, or hook and loop
fastener, and P-clamp.
12. Verify proper operation before you return the product to service.
EN 24 3504009001-A