Publicité
Les langues disponibles
Les langues disponibles
4. Reverse steps to reinstall.
5. Verify proper operation before you return the product to service.
T T a a b b l l e e t t u u p p g g r r a a d d e e
T T o o o o l l s s r r e e q q u u i i r r e e d d : :
•
#3 Phillips screwdriver
•
Tape measure
•
Pick
P P r r o o c c e e d d u u r r e e : :
1. Using a tape measure, find the approximate position of a tee nut (Figure 10).
2. Using your finger, push on the fabric to feel the tee nut.
3. Using a pick, poke through the fabric into the tee nut that you located in step 2.
4. Using a #3 Phillips screwdriver, poke through the tee nut to enlarge the hole.
5. Using a #3 Phillips screwdriver, hold the tablet arm (A) in position and install one of the supplied screws and washers
(B) to secure the tablet arm to the bench arm (Figure 11).
6. Using a pick, poke through the fabric into the tee nuts of the remaining holes in the tablet arm.
7. Repeat steps 4-5 to install the remaining three screws and washers.
8. Verify proper operation before you return the product to service.
F F i i g g u u r r e e 1 1 0 0 – – T T e e e e n n u u t t l l o o c c a a t t i i o o n n s s
T T a a b b l l e e t t r r e e p p l l a a c c e e m m e e n n t t
T T o o o o l l s s r r e e q q u u i i r r e e d d : :
•
#3 Phillips screwdriver
P P r r o o c c e e d d u u r r e e : :
1. Using a #3 Phillips screwdriver, hold the tablet arm (A) in position and remove the four screws and washers (B) that
secure the tablet arm to the bench arm (Figure 11). Remove and discard the tablet. Save the screws and washers.
2. Reverse steps to reinstall.
3. Verify proper operation before you return the product to service.
3504009001-A
A
B
F F i i g g u u r r e e 1 1 1 1 – – T T a a b b l l e e t t a a r r m m
21
EN
Publicité
