Replacing The Doors - GE 20 Manuel D'utilisation

REPLACING THE DOORS

INSTALL CENTER HINGE
1
Install the center hinge on each side.
REHANG REFRIGERATOR DOORS
2
Lower the refrigerator door onto the center
A
hinge pin. Ensure that the plastic hinge pin
thimble is on the center hinge pin or inside
door hinge pin hole located in the bottom
of the door.
Hinge Pin
Securely tape the door shut with masking tape
B
or have a second person support the door.
C
Route wires through bottom left hinge pin slot.
Insert the top hinge pin into the hinge hole
on top of the refrigerator door. Make sure the
door is aligned with the cabinet and opposite
door. Attach the hinge to the top of the cabinet
loosely with the bolts.
Bottom
Left Hinge
Pin Slot
On left-hand doors, pass the wires and water
D
line through the center hinge pin. Then connect
the water line and 4-pin connector.
Center Hinge Pin
4-Pin
Connector
Installation Instructions
(Double Door Refrigerator Models only)
(appearance may vary)
Water Line
REHANG REFRIGERATOR DOORS (CONT.)
2
Make sure the gasket on the door is flush
E
against the cabinet and is not folded. Make
sure the door is straight and the gap between
the doors is even across the front. While
holding the aligned door in place, tighten
the top hinge bolts. Replace the hinge cover
and screw.
Hinge Cover
Top Hinge
Bolts
(appearance may vary)
REPLACE OPPOSITE DOOR
3
Follow the same procedure on the opposite
door. There is no water line or hinge cover.
ALIGN DOUBLE DOORS
4
If the top of the doors are uneven, first try to
raise the lowest door by turning the leveling leg
on the same side as the door until the doors
are even. If the unit rocks, re-adjust the leveling
legs to the extent that the unit is stable.
If the doors remain uneven, turn the adjustable
pin to raise, or lower, the left door to match
the right door. Use a 1/4" Allen wrench to turn
the pin.
REPLACE FREEZER DRAWER
5
Refer to the Replacing the Freezer Drawer
section for instructions.
29
Adjustable pin