Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SECTION 3: INSTALLATION
B. CONNECTING THE WATER LINE
If you are retrofitting the bottle filler to an existing cooler, follow the instructions starting on the next page
CONNECT THE BOTTLE FILLER TUBE
For the single Bottle Filler ready cooler, the tube to connect to the filler is found
inside the access panel (the compressor compartment). This tube supplies cold
water from the cooling tank to the Bottle Filler.
FOR SPLIT LEVEL BOTTLE FILLER READY COOLERS:
The tube to connect to the filler is packaged in the "dummy" unit.
a) First, remove plug from fitting on tank drain.
02/20 | Franke 036865-047
¼" OD tube to connect
to Bottle Filler
Remove tube from bag
b) Next, insert end of tube into fitting.
7
Publicité
Table des Matières
