Franke KEP Serie Installation page 14

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SECTION 4: SET-UP GUIDE
For HANDS- FREE BOTTLE FILLER ELECTRONICS
FACTORY DEFAULT PROGRAM SETTINGS ARE AS FOLLOWS:
• Units of measure: Gallons
• Water filtration: UNFILTERED unit
• Bottle Count: 0.5L (1 Bottle)
• Flow Rate: 1.2 GPM
• Dispensing time: 20 seconds maximum
• Filter Capacity: 1250 gallons [4731 litres] for a VersaFilter
To change the program settings, follow these steps:
Display
000000000
BOTTLES REUSED
(Home Screen)
LTR/GAL
GAL
UNFILT/FILT?
UNFILT UNIT
SELECT RATE
1.2 GPM UNIT
RESET 00000000
GALLON CNT
FILT CAPAC
OF 1250 GAL
[4731 LTR]
3 sec rule?
0.5L
Reset 00000000
BOT COUNT?
Bot Filler
Set_time: 20 s
RUN CAL
AGAIN?
02/20 | Franke 036865-047
Action
Depress button for 3 seconds to enter into the following menu settings and make changes. Note:
at anytime it will exit menu and save settings when idle for 10 seconds (no button press) and
revert back to Home Screen.
Depress button for 3 seconds to change from Gallons to Litres,
or momentary press to advance to next menu.
Depress button 3 sedonds to change from Unfiltered to Filtered unit,
or momentary press to advance to next menu.
To change flow rate, momentarily depress button to change whole gallon digit.
Depress the button for 3 seconds to advance to TENTHS of gallon digit. Depress momentarily to
change the digit. Hold 3 seconds to advance to the next menu.
Depress button for 3 seconds to reset Gallon or Liter count, or momentary press to advance to
next menu.
Depress button for 3 seconds to change filter capacity to 3000 GAL [11355 liters] for Galaxi green
filter,
or momentary press to advance to next menu.
Depress button for 3 seconds to switch from 0.5L bottle to 3 sec rule,
or momentary press to advance to next menu.
(The 3 Sec rule increases the bottle count based on a 3 second dispense.)
Depress button for 3 seconds to reset (Home Screen) BOTTLES REUSED count,
or momentary press to advance to next menu.
Depress button for 3 seconds to change maximum dispense time to 10, 20 or 30 seconds,
or momentary press to advance to next menu.
Depress button 3 seconds to run calibration again,
or momentary press to advance to next menu.
BOTTLES SAVED
BOTTLES SAVED
BOUTEILLES SAUVÉES
BOUTEILLES SAUVÉES
Ok
Ok
Service soon
Service soon
Service Recommended
Service Recommended
Status / Statut
Status / Statut
Push
Button
D'accord
D'accord
Service bientôt
Service bientôt
Service recommandé
Service recommandé
14

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

KepwebfKepac-ebf-sndKep8ac-ebf-sndKepac-ebf-gryKep8ac-ebf-gry

Table des Matières