Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SECTION 3: INSTALLATION
B. CONNECTING THE WATER LINE (continued)
STEP 2:
Disconnect tubing from the elbow on the valve. (Figure 4)
STEP 3:
Using the 38" piece of tubing provided, cut off 6" and install it on the end of the TEE. Install the remaining tubing onto the branch of the TEE.
Connect the other end of the TEE to the tank outlet tubing (tube that was disconnected from the elbow). (Figure 5)
STEP 4:
Route the TEE and tubing under the waste drain and connect the 6" length to the water valve elbow. (Figure 6)
24" TUBING
WATER
VALVE
6" TUBING
TEE
ELBOW
Figure 4
Figure 6
Figure 5
Go to Step 5 "Final steps"
02/20 | Franke 036865-047
10
Publicité
Table des Matières
