Before Calling Service - Samsung RS30GKASL Manuel

BEFORE USING ICEMAKER
Remove
- Hold the handle as shown in
Figure1.
- Slightly pull up the bottom part.
- Take out the ice bucket slowly.
Install
- Assemble the icemaker in the
reverse order of disassembly.
- Push the bucket in firmly until you
hear a clicking sound.
- If the bucket does not fit into its
place, turn the gear handle on its
back by 90 degrees and reinstall
it again as shown in Figure 2.

Before calling service

- Any sounds you hear when
the ice maker dumps ice into
the bucket are part of normal
operation.
- If you don't dispense ice for a
long period of time, the ice may
form clumps in the ice bucket. If ice clumps form,
remove the remaining ice and empty the bucket.
- When ice does not come out, check for ice stuck
in the chute and remove it.
- When Ice Off blinks on the display panel,
reinsert the bucket and/or make sure it's
CAUTION
installed properly.
- When the door is open, the Ice and water
dispenser do not work.
- If you close the door hard, it may cause water
spilling over the ice maker.
- To prevent dropping the ice bucket, use both
hands when removing it.
- To prevent injury, be sure to clean up any ice or
water that may have dropped on the floor.
- Do not let the children hang on the ice dispenser
or on the bucket. They may get hurt.
- Be sure not to put your hand or any object into
the ice chute. It may cause personal injury or
damage mechanical parts.
Removing residual matter inside the
water supply line after installing fi lter.
1. Turn ON the main water supply.
2. Press the Water button and push the Dispenser
Lever.
3. Flush 1 gallons of water through the filter before
use. (Flush approximately 6 minutes.) This will
clean the water supply system and remove air
from the lines.
12_ setting up
All manuals and user guides at all-guides.com
4. Additional flushing may be required in some
5. Open the refrigerator door and make sure there
Figure 1 Figure 1
Figure 2 Figure 2
Check the amount of water supplied
to the ice tray.
1. Lift up the icemaker cover and gently pull it out.
2. When you press the Test button for 3 seconds,
Ice Chute Ice Chute
Figure 3 Figure 3
CAUTION
- Do not press the test button continuously when
- When the bucket is not installed, the ice maker
- When Ice Off blinks on the display panel, reinsert
households.
are no water leaks coming from the water filter.
Ice Ice Water Water
A newly installed water fi lter cartridge may
cause water to briefl y spurt from the water
dispenser. This is due to air getting into the
line. It should pose no problem to operation.
the ice cube container is filled with water from
the water supply tap. Check to make sure the
amount of water is correct (see the illustration
below). If the water level is too low, the ice cubes
will be small. This is a water pressure problem
from within the main water pipes, not the
refrigerator.
1 1
Ice maker Ice maker
Test button Test button
- It will take a few minutes for the water to
reach the correct level after you push the
Test button.
the tray is filled with ice or water. Water may
overflow or ice jamming may occur.
does not work.
the bucket and/or make sure it's installed
properly.
Check the Check the
2 2
water level water level