Cleaning, Care & Maintenance - Buffalo GL346 Mode D'emploi

Cleaning, Care & Maintenance
Always turn off and disconnect the appliance from the power supply before cleaning.
•
• Use soapy water and a damp cloth to clean the exterior of the appliance.
• Dry thoroughly after cleaning.
De-scaling
In hard water areas limescale can build up within the appliance after prolonged use. For best taste and
extended appliance life, de-scale it regularly. Installation of a water filtration system is also recommended.
To de-scale the appliance:
1. Pour a solution of de-scaler and water into the appliance.
2. Brush the interior gently with a soft bristled brush.
3. Discard the solution collected in the jug.
4. Fill the appliance with clean water and turn back On to flush out the system. Flush out the system
thoroughly to remove any de-scaler residue.
5. The appliance is now ready for use.
Note: Use a suitable de-scaler and always follow the instructions on the
container.
BUFFALO recommend that this appliance is de-scaled every 3 months or more
often in hard water areas.
IMPORTANT: Failure to de-scale or maintain will invalidate your guarantee.
Troubleshooting
Fault
The unit is not working
Power light comes on
but water does not
reach temperature
The tap is leaking
GL346-GL349_ML_A5_v5_20210226.indb 5 GL346-GL349_ML_A5_v5_20210226.indb 5
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Power supply
Thermal fuse has activated
Thermostat fault
The tap has become loose
Solution
Check the unit is plugged in correctly and
switched on
Call BUFFALO agent or qualified Technician
Replace the plug fuse
Check power supply
Reset Thermal fuse (see page 4)
Call BUFFALO agent or qualified technician
Tighten the tap handle
UK
5
2021/2/26 14:37 2021/2/26 14:37