Product Description; Pack Contents - Buffalo GL346 Mode D'emploi

• Buffalo recommend that this product is connected to a circuit
protected by an appropriate RCD (Residual Current Device).

Product Description

GL346 - 10 litre Stainless Steel Water Boiler
GL347 - 20 litre Stainless Steel Water Boiler
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of
this machine will provide the best possible performance from your BUFFALO product.

Pack Contents

The following is included:
• BUFFALO Water Boiler
• Tap adapter
BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.
Operation
1. Remove the appliance from the packaging. Make
sure that all protective plastic film and plastic
coatings are thoroughly removed from all surfaces.
Note: Before using for the first time,
clean the interior of the appliance
and all parts in warm soapy water,
then rinse thoroughly.
2. Ensure the Temperature Control knob is set to 'OFF'.
3. Remove the lid and fill the appliance to at least half
of its capacity.
4. Replace the lid.
5. Connect to the mains power supply.
6. Set the Temperature Control knob to the required
temperature setting. The 'BOIL' indicator light
illuminates and the appliance begins to heat water.
WARNING: Reduce the set temperature if the water begins to boil. DO NOT
allow the water to boil constantly.
7. When the water has reached the set temperature the 'BOIL' Indicator light turns off and
the 'KEEP WARM' indicator light illuminates.
GL346-GL349_ML_A5_v5_20210226.indb 3 GL346-GL349_ML_A5_v5_20210226.indb 3
GL348 - 30 litre Stainless Steel Water Boiler
GL349 - 40 litre Stainless Steel Water Boiler
• Instruction manual
Temperature Control knob
UK
Lid
Handle
Tap
KEEP WARM
indicator light
BOIL indicator
light
3
2021/2/26 14:37 2021/2/26 14:37