External Control; Installer Test Mode - Anden A320V1 Instructions D'installation Et D'utilisation

EXTERNAL CONTROL

90-1854
90-1854
AIR SAMPLING
90-1854
frequently to minimize humidity swings, but increases cost to operate
due to more frequent fan operation� Press MODE when done to move to
the next screen�
RH OFFSET
90-1854
All manuals and user guides at all-guides.com
If using the dehumidifier on-board
control, leave DISABLED and press
MODE to go to the next screen�
If using an 8800 Series thermostat
as an external control, use the UP
or DOWN button to select
ENABLED, then press MODE to go
to the next screen�
Use the UP or DOWN button to
adjust how frequently the
dehumidifier samples the air to
determine whether or not to
dehumidify� Fewer minutes means
the dehumidifier will sample more
An offset can be applied to the
on-board humidity reading to
avoid discrepancies with other
humidity measuring devices in the
home� Use the UP/DOWN arrows
to select an offset from -5% to 5%�
Press MODE to exit the installer
set-up screens�

INSTALLER TEST MODE

If everything is properly wired, the dehumidifier and all of the
wired components will turn on and off during Installer Test
Mode to demonstrate that all are properly operating� Installer
Test Mode lasts for four (4) minutes� If the ON/OFF button is
pressed during test mode, the dehumidifier will exit Installer
Test Mode and return to the OFF screen�
DEHUMIDIFICATION ONLY
90-1854
90-1854
90-1854
90-1854
90-1854
If the dehumidifier is not
already OFF, press the ON/
OFF button to turn it off�
Press and hold the ON/
OFF button and MODE
buttons for 3 seconds� The
measured humidity, AIR
SAMPLING and TEST will
show on the display�
After three (3) minutes the
dehumidifier compressor
will turn on and
DEHUMIDIFYING will
replace AIR SAMPLING on
the control screen�
After one minute of
compressor operation, all
outputs will turn off and
DONE will blink for 3
seconds and then return to
the OFF screen�
English 11