Important - Bell & Ross BR 01 cyber skull sapphire BR-CAL.209 Notice Technique

ENGLISH
BR 01 CYBER SKULL SAPPHIRE
BR-CAL.209
Movement : hand-wound mechanical. Calibre BR-CAL.209. Power reserve
of approximately 50 hours.
Functions
43,5 mm, width 45 mm.
A
B
C

IMPORTANT

. Magnetic fields can adversely affect the accuracy of your
Magnetic fields
watch. Also, we would recommend that you avoid placing your watch near
electronic devices that may generate large magnetic fields (radio, smart-
phone, television, computer, tablet, loudspeakers etc.).
Water resistance. Once the watch is set, to ensure perfect water resistance,
push the crown back to position 0. Never operate the crown underwater.
MAINTENANCE
After being immersed in seawater, it is recommended to carefully rinse off the
watch and strap with fresh water. It is also recommended to have the water
resistance of your watch checked every two years.
: hours and minutes. : length
Case
0 1
GENERAL USAGE
Starting the watch.
wind the mechanism by turning the crown in a clockwise direction. After
approximately 40 rotations, the watch is fully wound. The power reserve is
approximately 50 hours when fully wound.
Setting the time. Pull the crown out to position 1. Set the time by rotating the
crown in the required direction.
A. Minute hand
B. Hour hand
C. Strap attachment
D
D. Crown
0. Wind the movement manually (rotate clockwise)
1. Set the time (rotate in either direction)
BELL & ROSS INTERNATIONAL WARRANTY
To benefit from your 2-year international warranty, your card must be activated
at the time of purchase by your approved Bell & Ross point of sale, and pre-
sented every time an operation is performed. You can now access the digital
version of this card and all the information relating to your watch by scanning
the QR code or visiting:
www.bellross.com/warranty.
To ensure a service that meets the brand's exacting standards, any servicing of
your watch must be carried out by the Bell & Ross service centre or a watchma-
ker approved by Bell & Ross. The warranty does not, however, include:
. Any damage caused by accidents or by inappropriate or improper use of the
watch (e.g. violent impacts, crushing, rough handling of the clasp).
. Any damage caused by repair or disassembly operations carried out by a retai-
ler or after-sales service centre not approved by Bell & Ross.
. The consequences of the watch and bracelet/strap ageing and normal wear
and tear.
3
Once the watch has been stopped (crown in position 0),