Maintenance, Repair And Disposal - Rettig BAYO Installation Et Entretien

BAYO - THERMOSTAT
ENGLISH
3. PAIRING
See chapter "First start up and pairing".
4. FUNCTION NOT IN USE
Do not change, should be EXT (shown EHt in display).
5. CALIBRATION OF THE TEMPERATURE SENSOR
IN THE REMOTE CONTROL
If the temperature displayed on the remote control for
any reason does not correspond to the temperature
measurement from your own (very well calibrated)
thermometer, it is possible to calibrate the remote control.
To calibrate the sensor in the remote control, proceed as
follows in installer mode
1. Continually press (5 sec.) "+" and "-" simultaneously,
(from mode)
2. Position yourself on segment "5" whose default value
is "No"
3. Modify the value by pressing buttons "+" or "-"
4. Validate by pressing on "OK", "Yes" will be displayed .
If you want to delete your calibration:
1. Position yourself on segment "5" which is displaying
"Yes"
2. Press "+" and a temperature value will be displayed.
3. Press "+" and "-" at the same time, "No" will be
displayed
4. Press "OK" Software version will be displayed
(not to be confused with a temperature value)
To return to the different operating modes, press "OK"
button a few times until "End" #9 is displayed and the
press "+" button.
6. NOT IN USE
7. NOT IN USE
8. SOFTWARE VERSION
Only for information
9. RETURN TO "MODE MENU"
The remote control displays "End", press "+" to quite the
tool menu and enter the mode menu.
28 | M16MI384 - A03 - 01/18
M16MI38A03_0118_RETTIG_BAYO + THERMOSTAT MILO - 3 LANG.indd 28
FACTORY RESET
Remote Control
• Take out the batteries and wait more than 5 minutes
before you put them back in.
• Press the fi nger button on the thermostat for 20 s until
both LED turn steady red/green. Release the button and
the two LED should start blink slowly and alternatively.
5. MAINTENANCE, REPAIR AND
DISPOSAL
IMPORTANT: Before carrying out any maintenance, take
care to turn off the appliance.
CLEANING
To guarantee the longevity of your appliance through
simple maintenance, we recommend you follow the fol-
lowing advice:
• To clean the radiator body, do not use an abrasive or
corrosive product, preferably use warm soapy water.
• For the body of the regulation box, use a dry cloth
(no solvent).
REPLACING THE REMOTE CONTROL BATTERIES
• When the light for batteries running low comes on, you
must change the batteries. Press on the clip on the
bottom part and pull on the front. Replace the batteries
with 2 brand new alkaline LR03 AAA 1.5V batteries.
• You have up to 2 minutes to change the batteries.
Beyond this time, if all the segments come on when
starting up again, you will have to programme your
thermostat again (calibration, safety temperature).
6. WARRANTY
The product is covered by a 10 years warranty except
for the electrical and electronic components that are
covered by a 2 years warranty.
8/01/18 14:24