General Information - Rettig BAYO Installation Et Entretien

1. GENERAL INFORMATION

• This appliance is a sealed electric radiator designed for
fi xed wall-mounted installation.
• This appliance conforms to the standards EN 60 335-1
and EN 60 335-2-30.
• This appliance is class II and has a protection level IP44.
• This appliance complies with the European Directive
2004/108/EC (CE Marking on all appliances).
• This unit is supplied with a 3 core connection cable.
• This radiator is equipped with a radio frequency room
thermostat (868 Mhz) which is designed to provide you
with comfort and energy savings. It is intended to be
controlled by a remote control. Its radio frequency
operating mode allows it to control several radiators.
It allows you to adjust room temperature directly or by
using different user modes.
2. INSTALLATION
POSITIONING
See separate instruction how to fi t the radiator to the wall.
IMPORTANT: Thermostat must never rest on the ground.
The thermostat must be set up away from water ejections,
direct sunlight or any direct thermal disturbance such as
a lamp, television, heating pipe, draft.
ELECTRIC CONNECTION
• The electrical installation must comply with local or
national regulations.
• The radiator must be connected to the electrical supply
using the supply cable fi tted to the unit.
• If the radiator is installed in a bathroom or shower
room, it must be protected with a residual current de
vice (RC D) with a rated residual current not exceeding
30 mA.
• The radiator should be connected by a suitable and
qualifi ed electrician. Please refer to the wiring diagram
in picture 1 for the connection of the radiator.
M16MI38A03_0118_RETTIG_BAYO + THERMOSTAT MILO - 3 LANG.indd 23
FIRST START UP AND PAIRING
• Remove the protection strips from the batteries of the
Remote Control.
When starting up the Remote Control for the fi rst time or
during a long battery change (longer than 2 minutes), the
appliance starts in mode.
= REMOTE CONTROL
TO ESTABLISH COMMUNICATION BETWEEN THE REMOTE
CONTROL AND THE THERMOSTAT (PAIRING)
• On the thermostat
1. Push the button "fi nger" (2d). For the fi rst 5 seconds,
LED2 (2c) will blink fast orange. This is the signal to
release the fi nger button and only LED2 (2c) will fast
blink which means that the radiator is now in pairing
mode:
d
2
c
2
b
2
a
2
BAYO - THERMOSTAT
ENGLISH
d
2
c
2
b
2
a
2
M16MI384 - A03 - 01/18 | 23
8/01/18 14:24