Choose Attachment Option - KitchenAid KUDS40FVPA Instructions D'installation

2 Dishwashers with control panel on
front custom panel dimensions
3 screws
per side
outer panel
Gently set outer panel aside. Lay the cutomer-supplied
custom panel face down on a non-scratching surface.
Position the outer panel on the back of the customer-
supplied custom panel as shown; make sure top edge of
the outer panel is aligned with the top edge of the
customer-supplied custom panel, and both panels are
centered side to side.
3
Mark pilot holes
Mark all four hole locations; remove outer panel and drill
3/32" pilot holes 1/2" (13 mm) deep, in customer-supplied
custom panel. Place the outer panel on the back of the
customer-supplied custom panel and align holes. Attach
outer panel to back of customer-supplied custom panel
with four #10 x 1/2" wood screws (not supplied). If the
customer-supplied custom panel is less than 3/4" (1.9 cm)
thick where the screws are attached, shorter screws maybe
required.
4
Attach body panel
Reinstall
3 screws
each side
Attach the panel assembly to the door by reinstalling the
three screws on each side.
Mark pilot
holes
Align top
edges
Customer-supplied
panel

Choose Attachment Option

WARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
Using two or more people, stand the dishwasher up.
Option 1, Countertop attachment:
Countertop attachment
brackets
IMPORTANT: The dishwasher must be secured to the
cabinet. There are two brackets on top of the dishwasher
that can be attached to the countertop if it is wood,
laminate or other similar surfaces. If your countertop is
marble, granite or other hard surface the brackets may
be moved to the sides of the dishwasher.
NOTE: Do not attach the dishwasher. This will be done
later.
Option 2, Dishwasher side attachment:
1
Remove brackets from the top
To remove the brackets from the top, flatten tab at back
of brackets with pliers, and pull the brackets out of the
slots.
tabs
17