Canceling A Cycle; Changing A Cycle Or Setting; Adding Items During A Cycle; Option Selections - KitchenAid Briva KIDS01EK Guide D'utilisation Et D'entretien

Use this cycle for loads with normal amounts
of food soil. (The energy-usage label is based
on this cycle.)
†
Main Rinse Purge Rinse
Wash
145°F
(61°C)
Use this cycle for light loads, light soil
or glassware.
Main Rinse Final
Wash Heated
Rinse
145°F 145°F
(61°C) (61°C)
Use this rinse
cycle for rinsing
dishes, glasses,
and silverware
that will not be
washed right
away.
Main Rinse Final
Wash Heated
Rinse
†
A small amount of water is run through the pump to remove soil
particles.

Canceling a Cycle

Anytime during a cycle, open the lid. Then press Cancel and
close the lid.
The dishwasher starts a drain. Let the dishwasher drain
completely. Select a new cycle.
To stop the drain
You can press Cancel again to stop the drain immediately.
Remember to drain the dishwasher before starting a new cycle.
To clear the indicators
Press Cancel before starting the dishwasher to clear all options
and cycles.
Final Dry Time Water
Heated (min) Usage
Rinse (gal/L)
37* 4.1/
145°F 15.7
(61°C)
Dry Time Water
(min) Usage
(gal/L)
21* 2.5/9.5
Do not use
detergent with
this cycle.
Dry Time Water
(min) Usage
(gal/L)
3 0.9/3.5

Changing a Cycle or Setting

During the first fill of a cycle
1. Open the lid.
2. Press a new cycle and/or options.
3. Check the detergent. Dishwasher must contain the proper
amount for the new cycle.
4. Close and latch the lid. The dishwasher resumes the new
cycle and/or option after a 5-second pause.
After the first fill of a cycle
1. Open the lid.
2. Press the Cancel pad.
3. Close the lid. Your dishwasher starts a drain. Let the
dishwasher drain completely.
4. Open the lid.
5. Select a new cycle and/or options.
6. Check the detergent. Dishwasher must contain the proper
amount for the new cycle.
7. Press the Start pad.
8. Close and latch the lid.

Adding Items During a Cycle

You can add an item anytime before the main wash starts. Open
the lid and check the detergent amount. If the detergent is still
visible, you can add items.
To add items
1. Turn the knob latch to stop the cycle. Wait for the spraying
action to stop before opening the lid completely.
2. Open the lid. If the detergent is still visible in the wash water,
you may add the item.
3. Close the lid firmly and turn knob to latch. The dishwasher
resumes the cycle after about a 5-second pause.

Option Selections

You can customize your cycles by pressing the SANI RINSE™
option. If you change your mind, press the option again to turn
the option off.
You can change an option anytime before the selected option
begins.
Press the Start pad to repeat the same cycle and option as the
previous wash cycle.
NOTE: If the last cycle you completed was a rinse cycle, when
you press the Start pad, the dishwasher runs the last full wash
cycle and option.
SANI RINSE™ Option
Select this option to raise the water temperature in the final rinse
to approximately 160°F (71°C). The SANI RINSE™ option adds
heat and time to the cycle.
NOTE: SANI RINSE™ is an option with the Pots/Pans, Normal,
and Quick Wash cycles.
11