PowerBright PW900-12 Mode D'emploi page 9

All manuals and user guides at all-guides.com
NOTE
•
Before connecting the ground, make sure that the inverter rocker switch is OFF (0).
•
Run the ground wire from the Grounding Terminal on the rear panel of the inverter.
•
The selection of a proper grounding point will depend on here you are suing the inverter.
The grounding terminal may be connected to the chassis of your vehicle or the grounding
system in your boat or to the earth if you are operating in a remote location.
•
Inexpensive sound systems may emit a "buzzing" sound when operated with the inverter.
This is due to inadequate filters in the sound system. There is no solution to this problem
short of purchasing a sound system with a higher quality power supply.
BLOWN FUSES
Your power inverter is equipped with two four 35 amp spade type fuses. With reasonable
care it should not be necessary to replace these fuses. Most blown fuses are the result of
reverse polarity or a short circuit within the appliance or equipment being operated. If the
fuses happen to blow, disconnect the appliance or equipment immediately, find the source
of the problem, repair it, and then install the new fuses. The fuse compartment can be
accessed easily by unscrewing the bottom panel of the inverter. You will find the fuse in the
location indicated by the diagram on page 8.
•
ALWAYS disconnect your power inverter from the 12V power source before opening the
panel to replace a fuse.
•
Do not install a fuse with a rating higher than 35 amps. Doing so may damage the inverter.
•
Make sure to correct the source of the overload which caused the blown fuse before using
the inverter again.
P A G E 9