Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
IN REVIEW
•
Never attempt to operate the PW900-12 from any power source other than a 12V battery.
•
The E 900-12 is designed to be connected to the power source with the supplied cables or
RP
with gauge wire. Do not attempt to modify the supplied cables.
•
Always make certain the power cable terminal connections run Negative (-) to Negative (-)
and Positive (+) to Positive (+). Check these connections frequently to make sure they are
remain tight.
•
While connecting the inverter to the power source, make certain the inverter is positioned
far away from any potential source of flammable fumes or gases.
•
Make certain the power consumption of the appliance or equipment you whish to operate is
compatible with the capacity of the inverter. Do not exceed 900 watts.
•
When attempting to operate battery chargers, monitor the temperature of the battery
charger for approximately 10 minutes. If the battery charger becomes abnormally warm,
disconnect it from the inverter immediately.
•
Use only 35 amp spade type fuses.
•
When operating the inverter with an automobile or marine battery, start the engine every
30 to 60 minutes and let it run for approximately 10 minutes to recharge the battery.
•
In the event of a continuous audible alarm or automatic shut off, turn the inverter OFF
immediately. Do not restart the inverter until the source of the problem has been identified
and corrected.
•
To avoid battery drain, always disconnect the inverter when not in use.
•
Do not expose the inverter to rain or moisture.
•
Avoid placing the inverter near sources of heat or in direct sunlight.
•
While in use, make sure the inverter is properly ventilated.
•
Do not operate the inverter near flammable materials, fumes or gases.
All manuals and user guides at all-guides.com
P A G E 1 1
Publicité
Table des Matières
