PowerBright PW900-12 Mode D'emploi page 5

All manuals and user guides at all-guides.com
CONNECTING YOUR INVERTER
1. Make sure the ON/OFF rocker switch located on the front panel of the inverter is in the
OFF (0) position.
2. Connect the cables to the power input terminals at the rear of the inverter making sure to
match the color coded cables to the color coded terminals, and tighten the screws to make
a secure connection. Do not over tighten these screws.
Black = Negative, Red = Positive.
3. Connect the cable from the Negative (-) terminal (BLACK) on the inverter to the Negative
terminal on the 12V power source. Double check the connection is secure.
4. Check that the cable you have just installed is properly connected. Make certain that the
cable is connected to the negative terminals on both the inverter and the 12V power source.
5. Connect the cable from the Positive (+) terminal (RED) on the inverter to the Positive
terminal on the power source. Double check that the connection is secure.
6. Turn the inverter rocker switch to the ON (|) position. The LED Indicator Light should glow
GREEN confirming that there is power running to the inverter.
7. Turn the inverter rocker switch to the OFF (O) position. The GREEN LED Power Indicator light
may blink briefly and/or the internal audible alarm may make a momentary chirp. This is
normal.
8. Check that the appliance to be operated is turned OFF. Plug the appliance into one of the
two AC receptacles on the front panel of the inverter.
9. Turn the inverter rocker switch to the ON (|) position. Turn the equipment or appliance on.
NOTE
•
Loose connections can result in a severe decrease in voltage which may cause damage to
the wires and insulation.
•
Failure to make a proper connection between the inverter and the power source will result in
reverse polarity. Reverse polarity will blow the internal fuses in the inverter and may cause
permanent damage to the inverter. Damage caused by reverse polarity is not covered under
the warranty.
P A G E 5