PowerBright PW900-12 Mode D'emploi page 12

All manuals and user guides at all-guides.com
TROUBLESHOOTING
Reason
Poor contact with the battery terminals
Using incorrect type of voltmeter to test
output voltage
Reason
Battery voltage below 10V
Equipment being operated draws too
much power
Inverter is too hot (thermal shutdown
mode)
Unit may be defective
P A G E 1 2
PROBLEM: Low or no output voltage
PROBLEM: Overload LED stays ON
Solution
Clean terminals thoroughly
Use true RMS reading meter
Solution
Recharge or replace battery
Use a higher capacity inverter or do not
use this equipment
• Allow inverter to cool
• Check for adequate ventilation
• Reduce the load on the inverter to rated
continuous power output
See warranty and call customer service