Before Starting The Engine - Makita EB7660TH Instructions D'emploi

Masquer les pouces Voir aussi pour EB7660TH:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18

BEFORE STARTING THE ENGINE

Checking and refill of engine oil
CAUTION:
When refilling with engine oil, stop the engine
and wait for the engine to cool down. Otherwise skin burn may
result.
NOTICE:
Use of deteriorated oil will cause irregular start-up.
NOTICE:
Remove dust or dirt near the oil refill port before
detaching the oil cap. Also, keep the detached oil cap free of
sand or dust. Otherwise, any sand or dust adhering to the oil cap
may cause irregular oil circulation or wear on the engine parts,
which will result in troubles.
► 1. Oil gauge 2. Upper limit mark 3. 100 ml level 4. Lower limit
mark
Inspection
Put the blower on a flat surface and remove the oil cap.
Check the oil gauge. Make sure that the oil level is within the upper
and lower limit marks. If the oil is not up to the 100 ml level, fill up with
new oil.
Change the oil whenever it becomes dirty or significantly changes
color. (Refer to "Replacing engine oil" for the oil change procedure
and frequency.)
Refill
Put the blower on a flat surface and remove the oil cap.
Fill the oil up to the upper limit of the oil level gauge.
On average, engine oil needs to be added after every 20 hours of
operation (every 10 – 15 refuellings).
Recommended oil
Makita genuine 4-stroke engine oil or
API grade SF class or higher, SAE 10W-30 oil (automobile
4-stroke engine oil)
Oil capacity
Approximately 220 ml
NOTICE:
Store the blower in an upright position on flat sur-
face. The oil gauge does not indicate correct amount of oil if the
blower is leaned and oil is flown into the engine. It may result in
filling too much oil.
NOTICE:
Do not fill with excessive oil. Excessive oil may spill
from the breather of the air cleaner and make surrounding parts
dirty, or white smoke may appear due to burning oil.
After refilling with oil
Wipe spilled oil with a rag.
Fuel supply
the engine to cool down. Otherwise ignition, fire, or skin burn may
result.
to prevent ignition or fire. Never bring the fire (smoking, etc.)
near the place of fuel supply.
ble place. Refuel in good light and visibility.
spilled out by internal pressure.
cause allergies or irritation. When any physical abnormality is
1
detected, consult the medical specialist immediately.
NOTICE:
Fuel
from direct sunshine.
2
The engine is a four-stroke engine. Be sure to use an automobile gas-
3
oline (regular gasoline or premium gasoline).
4
NOTICE:
stroke oil or motor oil. Otherwise, it causes excessive carbon
accumulation or mechanical troubles.
NOTE: Keep fuel in a special container in a well-ventilated and
shaded area. Use fuel within a period of 4 weeks. Otherwise,
fuel may deteriorate in one day.
Refuelling method
replace it.
it every two to three years.
NOTICE:
1.
2.
fuel tank so that the refuel port is oriented upward. DO NOT fill fuel up
to the top of the tank.
3.
8 ENGLISH
WARNING:
When refuelling, stop the engine and wait for
WARNING:
Fuel supply must be made in a place free of fire
WARNING:
Refuel on flat surface. Do not refuel on unsta-
WARNING:
Open the fuel tank cap slowly. The fuel may be
WARNING:
Take care not to spill the fuel. Wipe spilled fuel.
WARNING:
Carry out fuel supply in a well-ventilated place.
WARNING:
Refuel at open clear place.
WARNING:
Handle the fuel with care.
CAUTION:
Fuel sticking to the skin or entering an eye may
DO NOT put oil in the fuel tank.
WARNING:
Keep the machine and tank at a cool place free
WARNING:
Never keep the fuel in a car.
Never use gasoline mixed with any oil such as 2
CAUTION:
If there is any flaw or damage on the tank cap,
CAUTION:
The tank cap wears out in course of time. Replace
DO NOT put fuel in the oil fill port.
Loosen the tank cap a little to release the tank pressure.
Detach the tank cap, and refuel, with discharging air by tilting the
After refuelling, securely tighten the tank cap.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Eb7660wh

Table des Matières