Cleaning And Maintenance - Teamtex RAGA Mode D'emploi

Once the headrest is adjusted to the height of the child:
1. Place the child in the seat. Pull the vehicle safety belt and pass it in front
of the child until it reaches the vehicle seat belt buckle.
2. Insert the clasp into the vehicle seat buckle. You should hear a click.
3. Place the diagonal part of the belt and the part that crosses the lap on the
side of the vehicle safety seat buckle, through the abdominal belt guide
(D)
of the safety seat (fig. 4.5).
4. Pass the diagonal part of the belt through the diagonal belt guide
the headrest until it is fully extended and not twisted
5. Make sure the diagonal part of the belt passes over the child's collar bone
and not the neck.
CAUTION! Make sure the belt is not twisted.
IMPORTANT! The part of the abdominal belt should rest as low as possible
over the child's hips, on both sides.
TIP: If the seat back covers the guide (C), you can raise the headrest (B),
which will allow you to insert the diagonal section of the belt easily. You
should then reset the headrest to the correct height.

5. CLEANING AND MAINTENANCE

1. Straps and plastic parts should be cleaned using a neutral detergent and
warm water.
2. Make sure soap does not enter the buckle or other metal parts.
3. Do not use chemical products or bleach on any part of the seat.
WASHING INSTRUCTIONS:
• The cover is removable and can
be washed at 30°. It should not be
machine dried.
• Machine wash – Cold cycle.
• Do not bleach.
If you have any doubts or queries regarding the use or placement of this product
or you need any replacement elements, please contact our Customer Services
Department.
• For dry cleaning use
any solvent except
trichloroethylene.
• Do not use a drier.
• Do not iron.
EN
(C)
on
30 °C
21