Installation Positions Within The Vehicle - Teamtex RAGA Mode D'emploi

2. INSTALLATION POSITIONS WITHIN THE VEHICLE

WHERE:
In the vehicle rear seats.
*Please, do NOT install the safety seat in forward seats except for the
following cases:
1. Whenever the vehicle does not count with rear seats.
2. When all rear seats are already occupied by children exceeding 135 cm
height.
3. When it is not possible to install all child restraints systems in the rear
seats.
*Note: According to Spanish legislation for child restraint systems (Royal Decree 667/2015).
HOW:
100-135cm (4-9 years approx.) • Install forward facing.
135-150cm (9-12 years approx.) • Install forward facing.
When used for stature heights between 135 cm and 150 cm, RAGA i-Size might not fit
in all vehicles.
In seats with:
ISOFIX anchorages (between seat and backrest) and vehicle belt.
NOTICE:
The child seat must only be used in this seat IF it has a lap and diagonal
belt (3 points).
3. CAR SEAT INSTALLATION MODES
3.1. ISOFIX system installation + vehicle belt
1. Unfold the ISOFIX arms pressing the unlocking button
isoclick arms will be totally extended when they´re blocked.
2. Place the safety seat on the car seat.
3. Hold the safety seat with both hands and insert the two ISOFIX arms
firmly into the vehicle anchors until they fasten with a click on both sides.
The red button will change to green on both sides (fig. 3.2).
4. Push the safety seat towards the back using a firm, constant pressure on
both sides until it rests firmly against the vehicle seat.
5. Shake the seat to check that it is correctly anchored to the vehicle's seat.
6. Pull the headrest height adjuster
until see the diagonal belt guide (C).
7. Insert the vehicle belt inside the diagonal belt guide
(A) and move the headrest up (Fig. 3.3)
(C)
EN
1
2
(F)
(fig. 3.1). The
(E)
(fig. 3.4)
19