Broan Elite EW54 Serie Mode D'emploi page 9

15. REINSTALL FILTERS
Rest filters springs in range hood inside rear groove. Using finger cup, tilt up the filters into position.
Make sure both screws located in the front panel edge of the hood are securely engaged in both
filters oval holes (A) after installation.
16. LIGHTING
The Broan Elite EW54 Series range hoods require two shielded Halogen Bulbs (120 V, 50 W max., MR16 or PAR16 with
GU10 base), included. See service parts list for replacement bulbs.
Do not touch lamps during or soon after operation. Burns may occur. In order to prevent the risk of personal injury,
only install shielded halogen lamps. Also, never install a cool beam, a dichroic lamp, a lamp not suitable for use in
recessed luminaires or identified for use in enclosed fixtures.
HR0124
1. Align the bulb leads with the small indentations located on the border of the lamp location on hood (see inset above), then
install the bulbs by placing the bulb leads into their grooves in the socket.
2. Gently push upwards and turn clockwise until secure.
NOTE: The suction cup tool (included with hood) can be used to install and remove light bulbs. Press suction cup tool on bulb and rotate
counterclockwise to remove bulb or clockwise to install bulbs.
Most GU10 LED replacement bulbs commonly found on the market are not designed for use in a cooking
environment and might not perform as advertised. Their usage with this product is not recommended.
All manuals and user guides at all-guides.com
BULB LEADS
WARNING
!
BULB LEAD GROOVES
( )
IN SOCKET
CAUTION
9
HD0939
A
SUCTION CUP
TOOL