Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. CHOOSE THE OPENING (
F
:
OR HORIZONTAL DISCHARGE
From outside the unit, remove the knockout from back of hood (see illustration beside).
5. BLOWER REMOVAL (HORIZONTAL DISCHARGE ONLY)
The EW54 Series range hoods are factory shipped with the blower mounted for a vertical discharge configuration. For a horizontal discharge
configuration, disassemble the blower from the inner top of the hood (see procedure below). It will be assembled to the inner back of the hood
once the hood is mounted on the wall.
1) Unplug the blower.
HD0817
6. INSTALL ADAPTER/DAMPER
Mount the 6" round adapter/damper
(included in bag) using 4 no. 8 x 3/8"
screws (included) or the 3¼" x 10"
adapter/damper to the hood using 2
no. 8 x 3/8" screws (included). Seal
the adapter/damper to the hood
using metal foil duct tape.
Secure the adapter/damper to the back of the hood using 2 no. 8 x 3/8" screws
(included). Seal the adapter/damper to the hood using metal foil duct tape.
NOTE: The wall ducting must be properly prepared to receive the adapter. Before
performing the installation, make sure the adapter fits easily in the duct.
All manuals and user guides at all-guides.com
)
CONT'D
2) Using a 5/16" socket, or a
Robertson or a Phillips no. 2
screwdriver, remove the 4 blower
mounting screws (2 on each side)
from the inner top of the hood. Set
the blower and screws aside.
V
ERTICAL DISCHARGE
HJ0139
5
HR0123
L
EFT SIDE MOUNTING
SCREW LOCATIONS
HD0385
6"
V
ROUND
ERTICAL DISCHARGE
HJ0140
H
ORIZONTAL DISCHARGE
HJ0129
R
IGHT SIDE MOUNTING
SCREW LOCATIONS
HD0386
3¼"
10"
X
3¼"
10"
X
ONLY
Publicité
Table des Matières
