Using Earphones - Shure KSE1200SYS Guide De L'utilisateur

Masquer les pouces Voir aussi pour KSE1200SYS:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
All manuals and user guides at all-guides.com
Setup
Step 1: Safely connect the earphones to the
amplifier
Plug into the amplifier with the amplifier powered off. This is
recommended to avoid hearing damage.
Note: Align the red dot on the earphone cable connector with the red
dot on the amplifier earphone output. To Disconnect from the amplifier:
Pull the knurled connector collar up to safely release the lock on the
earphone cable.
Step 2: Connect a sound source to the amplifier.
Plug the audio device into the LINE IN input.
LINE IN
Step 3: Power on the amplifier
To charge the battery while listening to audio, connect the
amplifier to a computer, external battery, or AC power source.
Note: Volume should be adjusted only by using the amp volume knob
for best performance. Ensure that volume is optimized in your audio
source.
0dB
-10dB
DC IN
PAD

Using Earphones

Choosing a Sleeve
Select an earphone sleeve that provides the best fit and sound
isolation. It should be easy to insert, fit comfortably, and easy
to remove.
Wearing the Earphones
1.
Carefully insert the earphone into the ear like an earplug, so that a
tight seal is formed.
Important: If there is a lack of low frequency response (bass), the
earphone sleeve may not be forming a proper seal. Gently push the
earphone deeper into the ear canal or try using a a different sleeve.
Warning: Do not push the earphone sleeve beyond the ear canal
opening.
2.
Wear earphone cables over the back of the ear to keep them in
place during physical activity. Guide the cable down either the
front or back of the body, and use the cable cinch to tighten up the
remaining slack.
The fit of the earphone can greatly affect sound quality.
5
Soft Flex Sleeves: In small, medium,
and large sizes. Made from pliable
rubber.
Soft Foam Sleeves: Compress the foam
sleeve between your fingers and insert
into the ear canal. Hold in place for about
ten seconds while the foam expands.
Triple-Flange Sleeves: If desired, use
scissors to trim the stem on the sleeve.

Publicité

Table des Matières
loading

Table des Matières