Before Use - Power Fist 8074668 Manuel Du Propriétaire

All manuals and user guides at all-guides.com
8074668manual 10/15/09
Warnings:
• Read, understand and follow all instructions before operating this device
• Do not exceed rated capacity
• Use only on hard level surface
• Lifting device only. Immediately after lifting, support the vehicle with
jack stands
• Do not move or dolly the vehicle while on jack.
• Failure to heed these warnings may result in personal injury and/or
property damage
• Lift only on areas of the vehicle as specified by the vehicle
manufacturer
• No alterations should be made to this product

Before Use

During shipment or handling, air in jack can become trapped in the
hydraulic system, causing jack to malfunction.
To release air from the hydraulic system:
1. Install handle.
2. Turn handle counter-clockwise no more than two full turns.
3. Remove oil fill plug.
4. Pump jack handle quickly in several full strokes.
5. Repeat above steps as needed. Remember to replace oil fill plug.
To raise:
1. Place vehicle in PARK (in gear on standard transmissions) and apply
emergency brake.
2. Close release valve tightly by turning handle clockwise.
3. Centre jack under load so that saddle contacts load firmly and will not
slip. Refer to vehicle owner's manual for proper lifting points.
4. Pump handle up and down until saddle contacts load. Check to ensure
that saddle is centred correctly before continuing. If not, recentre and
continue.
To lower:
1. Open the release valve VERY SLOWLY by turning the handle counter-
clockwise.
1:54 PM Page 2