Checking Tire Pressure - Cub Cadet 19A40026100 Mode D'emploi

10. Lift the tailgate latches and then lift the tailgate into place.
See Figure 3-7.
2
11. When the tailgate is in position, secure it in place by
snapping the tailgate latches onto the tailgate. See Figure
3-8.
8 S 3— A
ection SSembly
1
1
Figure 3-7
Figure 3-8
& S -U
et p
12. Remove the clevis pin and the cotter pin from the tongue
bracket. See the inset in Figure 3-9
1
3
Figure 3-9
13. Slide the tongue assembly into the tongue bracket as
shown in Figure 3-9. Line up the rear-most hole with the
hole in the tongue bracket and insert the clevis pin through
the tongue assembly and the tongue bracket. Secure the
clevis pin with the cotter pin as shown in Figure 3-9.
14. Be sure that the clevis pin is installed on the interior of the
tongue assembly and the tongue bracket as shown in the
inset in Figure 3-9.

Checking Tire Pressure

WARNING!
Equal tire pressure should be
maintained at all times. Refer to the tire sidewall for
proper pressure.
The tires on your hauler may be over-inflated for shipping purposes.
Adjusting the tire pressure before using the hauler may be required.
Check the sidewall of tire for maximum p.s.i.
NOTE: The recommended tire pressure is 14 p.s.i.
2