Key Pad Features; Led Display - Danby DAC060EB2GDB Guide D'utilisation Et Soins De Propriètaire

Operating Instructions

KEY PAD FEATURES

Temp / Timer
Control
68
Check
Filter
Auto
MODE
Mode
Selector
Energy
Saver
LED DISPLAY: Displays the following information independently - Set
Temperature, Ambient RoomTemperature and Auto Timer On/Off settings.
POWER: Turns unit On/Off.
NOTE: The unit will automatically launch the Energy Saver function when it is
in Cool, Dry, and Auto modes (only Auto-Cool and Auto-Fan modes).
MODE: Allows you to scroll through and select the desired operating
mode:
ed by the adjacent indicator light. * 'Auto' is a pre-set factory program that
automatically defines the mode (Cool or Dry) and fan speed, based on the
set temperature. The unit will automatically launch the Energy Saver function
High and Auto during Cool and Fan Only mode. Please note, during 'Dry'
mode the fan speed is automatically defined.
compressor is not in use. This function is available in Cool, Dry, and Auto
modes (only Auto-Cool and Auto-Fan modes). The fan will continue to run for
3 minutes after the compressor shuts off. The fan then cycles on for 2
minutes at 10 minute intervals, until the room temperature is above the set
temperature. At this point, the compressor turns back on and cooling starts.
the Temperature setting in 1°C / °F increments, and Auto-Timer On/Off set-
tings in 30min./1hr. increments. Note: This appliance allows you select the
temperature scale to be displayed in either "Celsius" or "Fahrenheit"
according to your preference.To change the temperature scale displayed
on the electronic display, press both the "Temp/Timer"adjust arrows simul-
taneously to alternate between "Celsius" & "Fahrenheit".
reminder to clean the air conditioner filter (see page 14). Once the filter has
been cleaned and replaced, depress the Check Filter button in order to
LED
resume operation.
Display
(when in cooling mode) by 2°F one half-hour after Sleep mode has been
Auto
selected. The temperature will then increase by another 2°F after an addi-
Timer
tional half hour. This new temperature will be maintained for 6 hours before
returning to the originally selected temperature. This ends the Sleep mode
Sleep
and the unit will continue to operate as originally programmed. The Sleep
Mode
mode program can be cancelled at any time during operation by pressing the
Sleep button again.
Auto
AUTO-TIMER: Used to initiate the Auto On/ Auto Off timer.
While the Air Conditioner is off (Auto-On):
1) Press the Auto-Timer button once and the adjacent Auto-On indicator
Fan
light will illuminate.
Speed
2) Use the Temp/Timer control cursors to select a delayed On time of
up to 24 hours.
3) Select the appropriate mode under which you want the unit to operate
Power
(Auto-Cool-Dry-Fan Only)
Button
4) Select the fan speed setting.
5) The time you selected will appear in the LED display.
Cool , Dry , Fan Only and *Auto. The selected mode will be denot-
FAN SPEED: Select from four different fan settings: Low , Medium,
ENERGY SAVER: Automatically cycles the fan on and off while the
TEMP / TIMER CONTROL: Used to increase or decrease
CHECK FILTER: The adjacent indicator light will illuminate as a
SLEEP MODE: In this mode, the selected temperature will increase
7