Velleman CAMCOLVC18 Mode D'emploi page 8

3. Insert an SD card (not included) in the card slot [7]. Push it in until it
clicks into place.
4. To remove the SD card again, push the card gently so that it pops out.
5. Screw the cap [1] back onto the back of the camera.
Formatting a Memory Card
Caution: Formatting erases all data from the card. If necessary, connect
the camera to a pc to back up the data before formatting.
1. Make sure the camera is switched off.
2. Insert the memory card in the card slot [7].
3. Switch the camera on.
4. Press the record button
The display shows "FOR" ( for "formatting').
5. Wait until the display shows the remaining recording time again.
The card is now empty and ready for use with the camera.
7.4 Configuration
Setting the Video Resolution
You can set the resolution of the recorded video to 720p (1280×720) or
VGA (640x480).
To set the resolution:
1. Switch the camera on.
2. Press and hold the menu button
The 720p icon
3. Press the record button
blinks.
4. Press the menu button to confirm.
Note: The remaining recording time is adjusted to the resolution. You can
record longer in VGA mode (lower resolution) than in 720p mode.
Setting the Time and Date
1. Switch the camera on.
2. Press and hold the menu button for 2 seconds.
The 720p icon
3. Press the record button repeatedly until "ALL" appears on the display.
4. Press the menu button for 2 seconds.
"Y" (for "year") and the third digit of the year blink on the display.
5. Press the record button repeatedly to set the digit. Then press the menu
button to confirm and move to the next digit.
6. Repeat for the last digit of the year, the month ("M"), day ("D"), hour
("H"), and minutes ("M").
The camera returns to video recording mode after you set all the digits.
V. 02 – 02/10/2012
CAMCOLVC18
for about 5 seconds.
for 2 seconds.
blinks.
once to switch to VGA. The VGA icon
blinks.
8 ©Velleman nv