Setting Up The Device - Beko HNS61210W Mode D'emploi

5

Setting Up the Device

A
WARNING
Please read saffety instructions before set-
ting up.
C
NOTE
Please refer to page 144 for the installation
guide
WARNING
A
Failure to install the screws or fixing device
in accordance with these instructions may
result in electrical hazards.
5.1 Installation
The hood is designed to be used either for exhausting or filter
version.
Ducting version
The cooker hood has an upper air duct B1 and an optional rear
air duct B2*, for external fumes exit.
Select the suitable air duct and apply the flange C supplied,
ensure to close the unused hole duct with cap D* supplied
if provided.
NOTE
C
In some models upper hole B1 is supplied
closed: Press firmly to detach the detachable
part that closes the outlet hole and remove it.
ATTENTION!
A
The detachable part cannot be mounted in
position again. Carry out this operation only
if you are sure of the type of installation to
make.
Hood / User Manual
All manuals and user guides at all-guides.com
CAUTION!
In some models the rear hole duct is not
easily accessible, even when the tap (if
A
mounted) is removed, in this case remove
the plastic piece E1 or E2 that is blocking
the hole duct, by unwinding using pliers and
cutter. Check that the filter/suction selector
(inside the cooker hood) G is in the suction
(A) position.
Filter version
In the case where it is not possible to discharge the cooking
fumes externally, the cooker hood may be used in the filter
version by fixing a carbon filter, the fumes and vapours are
recycled via the anterior grill placed above the control panel.
Check that the filter/suction selector (inside the cooker hood) G
is in the filter (F) position.
The models with no suction motor only operate in ducting
mode, and must be connected to an external suction device
(not supplied).
The connecting instructions are supplied with the peripheral
suction unit.
The minimum distance between the supporting surface for the
cooking equipment on the hob and the lowest part of the range
hood must be not less than 65 cm from electric and gas or
mixed cookers.
If the instructions for installation for the gas hob specify a
greater distance, this must be adhered to.
11 / EN