PROUSER DRC7010 Mode D'emploi page 7

OPERATION
st
Before the 1 operation: Please pair the monitor to your camera(s) !
(Please refer to the instructions below)
The monitor unit can be paired with a maximum of 2 cameras. Use the
Up/Down buttons in order to switch between the connected cameras or to show
a splitted screen.
General Usage:
Select the desired menu item by using the Up/Down buttons. Then confirm your choice
with the OK button. Press the Menu button to exit a submenu or wait a few seconds
without any input to exit automatically.
Power button
Press the Power button to power-on the monitor. The screen on the monitor will turn on
automatically when the vehicle is in reverse gear (when already paired to the camera(s)
as described below). When the monitor is on and gets a signal, the blue LED will light up,
otherwise it will blink. When the monitor is off, no picture will appear on the screen and
the blue LED will be off.
Menu / Return
Up /Auto Mode
Down / Manual Mode
OK (Confirm)
Lines
Power (On/Off)
7