Bushnell DIGITAL NAVIGATION 70-0002 Manuel D'instructions page 6

unsuccessful, the Cardinal Points will blink and you will have to repeat the previous 4 steps again.
To skip setting the declination, press the ADJ button to return to the Compass Mode.
Declination Setting
Declination adjusts the compass for the local magnetic fields. In
some areas, magnetic declination can be considerable, so it is a good
idea to check for declination on your map or on the Internet. To
adjust the compass declination angle, go to Compass Mode and hold
down ADJ button for 3 seconds, and the Compass Homing Mode
is displayed. Press MODE button until you get into Declination
Setting Mode displayed as 'DEC'. Press UP or DOWN button for
desired value then just press ADJ button to save settings and exit the
mode. Declination is sometimes measured as degrees positive and
negative. Degrees East are considered positive and Degrees West are
considered negative. For example, to change from 3 degrees East
(positive) declination to 3 degrees West (negative) press the DOWN
button until 3W appears.
Self Homing Mode
Allows you to preset a reference bearing which tells the Compass to
alert you to the direction you should be heading. Go into Compass
Mode and press MODE button to display compass Homing. To
adjust homing bearing, press and hold ADJ button for three
seconds. Press UP button or DOWN button to adjust to desired
bearing setting. Pressing UP or DOWN will increase or decrease
bearing by increments of ten. A single push of UP or DOWN moves
bearing by 1 degree. When done, press ADJ to return to Homing
mode. To return to Compass Mode press MODE button.
To operate the compass in Homing Mode go into the Compass Mode first, then press MODE
button to get into Homing Mode.
The main reading displays the actual bearing and the lower reading shows the 'home' bearing. The
segments on the circumference show the difference between the two bearings, which can be used
to redirect you to stay on course.
8
To conserve energy the display in the Homing Mode will show 3
'bars' instead of the current bearing, and the segments will not be
displayed after 1minute. To activate the display again you must press
COMP. To exit the Homing Mode press MODE again to return to
default Compass Mode.
A B L
UTO ACK IGHT
Press the LIGHT button to turn on LCD backlight for 5 seconds.
Night Mode
Night Mode allows the backlight to come on automatically when any of the function keys are
pressed except when the compass is in Compass Mode. Press and hold down LIGHT button for
3 seconds, and the Night Mode icon (represented by the light symbol) appears. To turn off press
and hold down LIGHT button until the light symbol disappears.
B
ATTERY
Installing a Battery
To open the battery compartment cover, insert a coin in the coin slot
and rotate cover in a clockwise direction until it lifts open. Insert the
lithium cell (battery type: CR2430) into the compartment, making
sure that the negative polarity faces downwards. Close battery
compartment cover until it clicks shut.
Low Battery Indicator
A blinking battery icon will appear when the battery is low. The
battery compartment is on the back of the compass. Replace the
used battery with a CR2430 lithium battery. Note: The watch is
automatically reset when the battery is removed.
Battery Life
Your DNS is designed for continuous use and batteries will last over one year with regular usage.
Heavy use of the alarms, light, or compass will shorten battery life.
9