Pentair GLOBRITE Mode D'emploi page 21

Set up a GloBrite ™
To setup an AUX circuit to control the GloBrite
an auxiliary relay circuit (AUX 1), then assign the circuit name for that light circuit. The light
circuit name will appear on the main screen. Each GloBrite light must also be assigned a
circuit function.
To assign a Circuit Name for the GloBrite light, go to: MENU > SETUP > ADVANCED
> CIRCUIT FUNCTIONS
Setup a GloBrite light function circuit: Assign each light auxiliary relay circuit a
circuit name, then assign that light relay circuit in the "CIRCUIT FUNCTIONS" section,
as "INTELLIBRITE."
To setup the GloBrite light circuit function (use the "IntelliBrite" circuit name):
1. Press the button next to the AUX button (the relay auxiliary circuit
connected to the GloBrite (IntelliBrite) light).
2. Press the right or left side (PREV/NEXT) button next to "INTELLIBRITE."
Scroll through the circuit functions until "INTELLIBRITE" is displayed.
3. Press the SAVE button on the bottom of the screen. Press the EXIT button to
return to the main screen.
Assign the GloBrite light circuit to the Lights screen:
4. Press the Lights button on the bottom of the screen.
5. Press the right side button next to "CONFIGURE."
6. Press the button next to "NONE" to assign an IntelliBrite light circuit to the
selected button. Light names can be setup to display on the left side for
"Spa" features and on the right side for the "Pool" features.
7. Press the top left or right side button to scroll through the available light cir-
cuits which can be used for the GloBrite (IntelliBrite) lighting features. Select
at the circuit name you wish to use. The displayed circuit names are circuit
names that were previously assigned when assigning a circuit function.
Operating and Selecting GloBrite (IntelliBrite
Special Light Features: Up to twelve (12) IntelliBrite light circuits can be displayed on
the main Lights screen (special light features). From the Lights screen you can activate
the IntelliBrite lighting features (i.e., color swim, color set). Assuming each GloBrite
(IntelliBrite) light has its own relay and separate circuit.
Troubleshooting (GloBrite
Both of the LEDs are flashing: Check the light wiring connection to the junction
box at the pool side and to the AC power switch.
The light will not illuminate:
Check the light wiring connection to the junction box at the pool side and to the AC
power switch. Be sure that there is proper AC power applied to the light.
All manuals and user guides at all-guides.com
Light Circuit Function
™
Lights)
GLOBRITE™ White LED Light Installation and User's Guide
white light, assign the circuit light function
™
® White Light) White Mode
17