Before Use - Power Fist 8056608 Manuel

8056608manual 3/11/05 2:54 PM Page 4

Before Use

If the machine is new, the battery must be charged before first use. The battery is
housed in the handle. Swing open the battery retaining clip and remove the
battery from handle.
A new battery or one that has not been used for an extended period achieves full
performance only after approximately 5 charging and discharging cycles. A
substantial drop in operating period per charge indicates the battery is worn out
and must be replaced.
Battery charger
The power voltage supply must conform to that specified on the rating plate of
the charger. Always inspect battery charger, cord, and plug before use. Always
have damage repaired by a qualified professional.
• Protect battery charger from humidity and operate only in dry areas.
• The supplied charger is suitable for charging batteries only
Charging the battery
Start the charging process by plugging in the battery charger
and inserting the battery into the battery charger slot. The
batter and battery charger normally become warm during the
charging process.
After termination of the charging (approximately 3 to 5
hours) pull charger out of socket and remove battery. Do not
overcharge the battery.
To prevent incorrect battery insertion on the charger, please
insert the battery back so that the guide lines up with the
channel as shown.
Guide
About the charger
Disconnect the power supply before connecting or
disconnecting the battery
• The charger must be used only with the supplied battery.
Never use non-rechargeable type batteries.
• Do not expose the charger to rain or water.
• The charger must be used with the battery and with the adapter