Installation Of Harmonys Microphone; Identification Of The Harmonys Microphone Keys - Bodet Harmonys Notice D'utilisation Et D'installation

II - Installation of Harmonys microphone
Select the location where the Harmonys microphone will be installed by making sure of the
presence of the network cable PoE.
1/ The Harmonys micorphone is designed to be used on any flat surface: table, counter top, or
desk top. Mechanical intervention is not necessary for the installation.
2/ Connect the Ethernet network cable to the RJ45 connector.
Ethernet cable category: 5 minimum or 6.
The boradcast mode will have to be selected in the Technician Menu (see page 23), particularly
the Multicast address which must be the same as that of the server (by default 239.192.55.1).
Record the MAC address (identification label on the back of the product) of the product, it will be
useful during its detection by the Sigma software in order to rename it.
Power supply indicator :
LED green = device powered on.
LED OFF = no power.
III - Identification of the Harmonys microphone keys
Microphone Speaker
REC key
PLAY key
Possible combination with key
- : Recording of a vocal message. Remain rested during all the duration by the recording in
following the instructions on the screen
- : Listening of the prerecorded message on the integrated loud speaker.
- : Live broadcast of the message sent to the microphone.
- + : Broadcasting of the prerecorded message.
16
All manuals and user guides at all-guides.com
, ,
Network indicator :
LED flashing orange flash =
connection to the network in
progress.
LED flashing orange slowly = device
connected to the network
LED flashing red slowly = loss of
network connection or failure to
connect to the network.
LCD display
LIVE key
zones / groups selection keys
( 8 or 15)
: