I - Initial Verification; Unpacking The Harmonys; Cleaning; Pre-Requisit - Bodet Harmonys Notice D'utilisation Et D'installation

I - Initial Verification

Thank you for choosing a BODET Harmonys microphone. This product has been carefully
designed for your satisfaction based on ISO9001 quality requirements.
We recommend that you read this manual thoroughly before attempting to manipulate the
product.
Keep this booklet during all the life of your product, so that you can refer to it each time it is
necessary.
Bodet cannot be held responsible for damages caused to the product due to use that
does not conform to the instructions described in this manual.
Any unauthorised modification of the product will invalidate the warranty.

1.1 Unpacking the Harmonys

Unpack with caution and check the contents of the packaging.
Reference 907755 must contain:
■ Harmonys microphone 8 keys,
■ This booklet,
Reference 907756 must contain:
■ Harmonys microphone 15 keys,
■ This booklet,

1.2 Cleaning

Use an antistatic product identical to that supplied. Never use alcohol, acetone or other solvents
which may damage product casing.

1.3 Pre-requisit

For the commisioning of the microphone Harmonys you must install «SIGMA». This software is
available on BODET web site www.bodet-time.com as a free download.
Note: the Ethernet network connection to which the Bodet Harmonys microphone is connected
must be PoE, the power being supplied by a PoE switch or a PoE injector. Make sure that the
power capacity of your switch or injector is sufficient to power your product.
Bodet recommends the following brands:
■ PoE injectors: Zyxel, Tp link, D-Link, HP, Cisco, Axis, ITE Power Supply, PhiHong, Abus,
Globtek.
■ PoE switches: D-Link, HP, Planet, Zyxel, Cisco, NetGear, PhiHong.
All manuals and user guides at all-guides.com
15