Omega VRT330 Mode D'emploi page 15

SPINNING BRUSH ASSEMBLY, DISASSEMBLY AND WASHING
SPINNING BRUSH ASSEMBLY
Spinning Brush
1
2
3
SPINNING BRUSH DISASSEMBLY AND WASHING
1
Spinning Brush
2
3
Silicone Brush
Up
(Longer Part)
Brush
Grove
Down
(Shorter Part)
Silicone Brush
Cleaning
Brush
Check the groove of the spinning brush
and the direction of silicone brush.
• As shown to the left, let groove inserts
face the spinning brush.
Insert the silicone brush into the spinning
brush. The longer part should face upward.
Hold the outer wing of silicone brush with
your thumb and index finger and insert
silicone brush into the groove of spinning
brush.
Pull tight.
• Push silicone brush from the outer side of
spinning brush and pull 'inner wing' in the
direction of inside of the spinning brush
with the other hand as shown to the left.
• Pull it until you cannot pull it any longer.
If unit is not fully assembled, there is a risk
of breakage.
Remove the spinning brush from juicing
screen.
Detach the silicone brush from spinning
brush. As shown to the left, hold the outer
part of silicone brush with your fingers
and pull it out to the arrow direction. If
pulling it by force, silicone brush may be
torn or spinning brush may be damaged.
With cleaning brush, wash inside and
outside of spinning brush under running
water. Wash silicone brush in the same
way under running water.
13