Omega VRT330 Mode D'emploi page 11

HOW TO ASSEMBLE
1
2
3
4
Hopper
5
Juice
Spout
Base
6
Screen
Auto Cleaning
Brush
Red Dot
on Screen
Red Dot on Bowl
Bowl
Auger
Screen
Bowl
Arrow on Hopper
Red Dot on Bowl
Bowl
Open
Closed
Place the screen into the auto clean
brush.
Place the screen and the auto clean
brush into the bowl, making sure the red
dot on the screen and the red dot on the
bowl are aligned.
Push the Auger into the screen.
Assemble the hopper onto bowl.
• Make sure the arrow on the hopper and
the red dot on the bowl are aligned.
• Make sure the arrow on the hopper is
pointing to the "close" sign on the base.
Assemble the entire top set onto the base.
Assemble the bowl onto the base and
twist the bowl so that the hopper edge is
pointing to the "close" sign.
• Connect the power cord.
• Place containers under both ejection
spouts. (Juice & Pulp Ejection)
Underneath the bowl, there is a rubber
gasket which allows all the juice to only
discharge from the spout. The rubber
gasket is removable. Simply grab onto one
side of the rubber gasket and pull out.
9