Cleaning And Care - Klarstein ILLUMINOSA Mode D'emploi

EN
50

CLEANING AND CARE

Note: Prior to any maintenance work or cleaning, disconnect the appliance from the
electricity mains.
Cleaning the hob surface
• The surface of the hob, pan supports, enamelled burner caps (C) and burner heads
(T) (see fi gure 9) need to be cleaned after each time they are used with warm
soapy water, rinsed and then dried well to keep them in good condition. Never
clean when the top and components are still warm.
• Do not use metal or abrasive pads, abrasive powders or corrosive spray products.
Never leave vinegar, coffee, milk, salty water, and lemon or tomato juice for any
length of time on the surfaces.
WARNING
Risk of burns! Accessible parts may be hot, when the pan support is in
use. Young children should be kept away. Do not touch the LED light
board under the knobs in any situation.
Comply with the following instructions, before remounting the parts:
• Check that the heads burners and the relative burner caps are correctly positioned
in their housings (see fi gure 9).
• Check that burner head slots have not become clogged by foreign bodies.
• If to happened installation or after a few times, you fi nd a tap is diffi cult to open or
close do not force it but call for technical assistance urgently.
• After use, to keep them in good condition, the plates should be treated with specifi c
products, easily found in the shops, to keep the surfaces clean and shining. This will
also prevent rust from forming.
• If any liquid spills over it must always be removed with a sponge.