Klarstein ILLUMINOSA Mode D'emploi page 49

Lighting of burners equipped with safety thermocouples
(only certain versions, see figure 9, ref. Tc)
1. In case burners are fitted with Flame Safety Device (FSD = Thermocouple, figure 9,
Tc), repeat operations described previously.
2. Once the flame is alight, keep the knob pressed for about 10 seconds to allow the
Flame Safety Device (FSD = Thermocouple) to warm up. If, at the end of this time,
the burner fails to alight, it means that Flame Safety Device (FSD = Thermocouple) is
not sufficiency heated. Repeat the operation.
Optimum use of the burners
To get the maximum yield with the minimum consumption of gas it is handy to keep the
following points in mind:
• Once the burner has been alighted, adjust the flame according to your needs, from
"Maximum" position (big flame) to "Minimum" position (little flame).
• Use proper pan size (with flat bottom only) for each burner (see the table below
and figure 1 1).
• When the contents of the pan start boiling, turn the knob down to the "Minimum"
position with reduced rate (small flame).
• Always put a lid on the pan.
Item number Wok
10035464 24-26
10035465 24-26
10039896 –
Figure 11
Pan diameter (Ø in cm)
Rapid Semi­Rapid
–
24-26
22-24
Auxiliary
20-22 10-15
20-24 10-15
– 10-15
EN
49