How To Start Charging; How To Start Charging With Authentication - ZAPTEC Pro Manuel D'utilisation

Cable
ZAPTEC Pro needs a Type 2 charging point in order for you to be able to charge
EN

How to Start Charging

1. Check that the status indicator (Z) is illuminated green.
2. Remove the protective cover to gain access to the electrical outlet.
3. Attach the charging connector to the ZAPTEC Pro.
4. Attach the charging connector to your vehicle.
5. The status indicator will flash blue once charging has started.
Charging current may vary depending on the capacity of the installation and the number of
i
active charging stations.

How to Start Charging with Authentication

Charging with authentication requires you to have registered a user profile via ZAPTEC Portal
and for your user profile to have had access granted to them (via ZAPTEC Portal) to the charging
station/facility. The charging pass is linked to your user.
For details on how to set this up, see the section Connecting a Charging Pass to Your User.
The recommended authentication method is to use a charging pass.
Start charging with an authentication RFID tag/charging card:
1. Follow steps 1–4 in How to Start Charging.
5. The status indicator (Z) will now flash yellow to indicate that it is awaiting authentication.
6. Hold the charging pass up to the RFID zone; see the illustration in the section ZAPTEC Pro.
7. The status indicator will flash green once authentication is approved.
8. The status indicator will flash blue once charging has started.
If the status indicator is flashing red, see the Troubleshooting section for further details.
Start charging with authentication for automatic payment solution/operator
9