Publicité
Liens rapides
Publicité
Manuels Connexes pour ZAPTEC Pro Backplate
Sommaire des Matières pour ZAPTEC Pro Backplate
- Page 1 Zaptec Pro Backplate → Installer Manual Fully charged for your next adventure...
- Page 3 • Do not install or use a product which is damaged in any way. AS and direct partners to waive all liability and claims • Do not use high-pressure washers to clean the Zaptec Pro. for compensation. • Do not insert test probes, wires or anything else into the •...
- Page 4 Zaptec Charger AS • Non utilizzare un prodotto danneggiato in alcun modo. respinga eventuali responsabilità e eventuali richieste di •...
- Page 5 Install the back plate Mount the back plate and remove the cover on the junction box. Use existing holes! Creating new holes in the back plate will invalidate the warranty. Monter bakplaten Monter bakplaten, og fjern dekselet på koblingsboksen. Det er viktig å ikke lage nye hull i bakplaten.
- Page 6 Connect the back plate To reduce the risk of leaks in outdoor installations, please connect the cable to the bottom of the junction box on the backplate. If not possible, device must be properly sealed and checked. Connect the cables in the junction box in accordance with the electrical system at the location.
- Page 7 No daisy chaining is allowed. It is only allowed Ein Durchschleifen ist nicht erlaubt. Es ist nur when installation circuit breaker is no more erlaubt, wenn der Installationsschutzschalter than 40A. nicht mehr als 40A beträgt. Seriekobling er ikke tillatt. Det er bare tillatt hvis La connexion en série des plaques arrière est installasjonsbryteren ikke overstiger 40A.
- Page 8 Dept. Technical reference Created by Approved by Dept. Technical reference Created by Approved by Fredrik Ostrem 01.08.2017 Fredrik Ostrem 01.08.2017 Document type Document status Document type Document status Title DWG No. Title DWG No. ZCS_Sealing_Cone_8mm_v1 Untitled Rev. Date of issue Sheet Rev.
- Page 9 Använd rätt kabeltätning Utilisez le bon joint d’étanchéité • Liten kabeltätning: 10–16 mm. • Petit joint d’étanchéité : 10–16 mm. • Stor kabeltätning: 16–18,5 mm. • Grand joint d’étanchéité : 16–18,5 mm. • För inte in några främmande föremål • Ne pas insérer d’objets étrangers dans la prise i typ 2-uttaget.
- Page 10 230V 230V 230V...
- Page 11 REMOVE BEFORE INSTALLATION OF ZAPTEC Protect the connections Schutz der Anschlüsse Apply the adhesive sticker to protect the Kleben Sie den Aufkleber zum Schutz der connections if you are not installing the Anschlüsse auf, wenn Sie die Ladestation nicht charging station directly after.
- Page 12 Zaptec powers any EV Zaptec Charger AS Professor Olav Hanssens vei 7A 4021 Stavanger Norway Made in Norway zaptec.com © Zaptec Charger AS 31.07.2023. All rights reserved. MA-00015-A1 https://www.sparkli.fi/...