WARNING
!
•
Due to high temperatures, this electric appliance should be located out of traffi c. Keep combustible materials
such as furniture, pillows, bedding, papers, clothes and curtains at least 36" (91.4cm) from the front of the
appliance.
•
Never locate this electric appliance where it may fall into a bathtub or other water container.
•
Wear safety gloves and safety glasses for protection during installation and maintenance.
•
To prevent contact with sagging or loose insulation, the electric appliance must not be installed against vapor
barrier or exposed insulation. Localized overheating could occur and a fi re could result.
•
Do not expose the electric appliance to the elements (such as rain, etc.).
3.1
unpacking and testing the appliance
Carefully remove the appliance from the box. Prior to installing the appliance, remove all packaging material and
test to make sure the appliance operates properly by plugging the power supply cord into a conveniently located
120V, 15 Amp minimum grounded outlet.
note:
The appliance is shipped with the front glass not assembled onto the appliance (see "front glass installation
and removal" section for assembly instructions). Front glass must be installed during operation.
3.2
grounding the appliance
NEFL42-74CHS models are for use with 120 volts; NEFL42-100CHD models are for use with 240 volts. The
cord has a plug as shown in (A). An adapter as shown in (C) is available for conecting three-blade grounding type
plugs to two-slot receptables, as shown in (B). The green grounding plug extending from the adapter must be
connected to a permanent ground such as a properly grounded outlet box. The adapter should not be used if a
three-slow grounded receptable is available.
To disconnect appliance, turn controls to OFF, then remove plug from outlet.
Metal Screw
Cover of
grounded
outlet box
(A)
note:
This appliance must be connected to a dedicated 15 amp circuit. The use of an extension cord is NOT
permitted.
Grounding Methods
(B)
Grounding Pin
locating appliance
3.0 location
Not allowed in Canada
Adapter
(C)
Grounding Means
W415-2212 / F / 04.23.19
EN
9